Electrical Engineer III, Design Assurance
As an Electrical Engineer III, Design Assurance at Neros, you will bring up, characterize, and validate the circuit boards that go into our next generation airside and groundside platforms. You will write and run test plans, contribute to worst-case circuit analysis from schematic through bench validation, and design the fixtures and automated test setups behind that work. You will work with design engineers during product development to get results back into the design.
Key Responsibilities:
Bring up, characterize, and validate new circuit boards against requirements
Contribute to worst-case circuit analysis, from schematic-level calculations and simulation through post-layout checks and bench validation, feeding measured results back into the analysis
Write and execute test plans, procedures, and reports
Design and build test fixtures, hardware-in-the-loop (HIL) setups, and automated test scripts
Run qualification and reliability testing, including thermal, vibration, and HALT/HASS, and support root-cause analysis on failures
Provide design-for-test (DFT) input to design engineers during product development
You should have the following:
4+ years of experience in electrical hardware engineering, with hands-on bench validation of circuit boards
Board bring-up and characterization experience, including writing your own test plans and reports
Proficiency with bench instrumentation: oscilloscopes, logic and protocol analyzers, power supplies, electronic loads, DMMs, and spectrum analyzers
Board-level design experience: schematics and PCBs you designed yourself. Test fixtures and test boards count
Circuit analysis across analog, digital, and power supply circuits, including hand calculations, tolerance analysis, and SPICE simulation (LTspice or similar)
Test automation and data analysis in Python or similar
Bachelor's degree in electrical engineering or a related field
Nice to have:
Signal and power integrity simulation (HyperLynx, SIwave, or similar) and bench measurement (TDR, VNA, eye diagrams)
Hands-on WCCA and component derating on production hardware
Previous HALT/HASS, environmental, or EMC pre-compliance testing experience
Production test development with a contract manufacturer
Background in UAV, aerospace, automotive, defense, or medical device hardware
US Salary Range
$136,500 - $191,500 USD